Omega Speaker Cable (Pair)

DRIVEN BY SCIENCE
The Omega speaker cables represent the most scientifically advanced cable design in Shunyata Research’s history. More than a quarter century of research and development have produced a masterpiece in both design and performance. The Omega system represents a showcase for Caelin Gabriel’s patented science and innovative design acumen. The Omega speaker cables transcend expectations, delivering a truly immersive, three-dimensional listening experience.

When Omega speaker cables are paired with Omega analog interconnects and digital cables, the full realization of Gabriel’s design vision comes into focus. 

OMEGA TECHNOLOGY: Eliminating All Performance Constraints
OMEGA ΞTRON® More than a decade ago, designer Caelin Gabriel developed the patented ΞTRON® technology. Since then, he has continued to refine the original circuit’s design, measurably reducing dielectric-induced signal distortion to an almost non-existent level. Gabriel has developed a more advanced version of the ΞTRON® circuit to augment the Omega speaker cable’s HARP™ and TAP™ technologies. The audible and measurable performance improvement of the ΞTRON® circuit has clearly demonstrated its ability to visibly improve signal square-wave response. The impact this scientific advancement delivers is startling, even when compared to a major component upgrade.
US Patent: US8912436B2 // China Patent: ZL2011800473442 // German Patent: 601011046558.9 // UK Patent: 2622612 

OMEGA HARP™
This technology was created through Gabriel's research into current-drift and cable-induced signal reflections. HARP™ reduces audio frequency current transfer function resonances that can audibly smear transient response and obscure low level resolution. Gabriel's original design consisted of a single-element circuit that had proven to be quite effective at lowering perceived distortion while increasing resolution in Shunyata Research’s Alpha v2 and Sigma v2 speaker cable lines. Gabriel developed a far more complex four-element HARP™ circuit exclusively for the Omega speaker cable. The Omega “quad-HARP ” audibly reduces current resonance distortions throughout the audio frequency band. HARP™ technology, perhaps more than any previous innovation, is responsible for the Omega speaker cable’s vanishingly low noise floor, unparalleled low-level signal recovery and its stunning dynamic contrasts.

‌TAP (‌‌Transverse Axial Polarizer)
A patent-pending technology which reduces signal polarization distortion. A simple analogy for Omega TAP™ is how polarized sunglasses reduce glare on a sunny day. The application of TAP™ technology in the Omega speaker cables delivers a significant increase in resolution and a drop in the noise floor that simply cannot be achieved by another method or technology. The fact that this technology is passive and does not alter or impede current flow or signal transfer is in keeping with Gabriel's core design principle of preserving a pure and unfettered signal path.~ Patent Pending ~

OFE Copper Alloy 101
Shunyata uses only the highest purity of copper available for the production of its wire products.  OFE Alloy 101 or C10100 is the highest grade of copper with a minimum 99.99% purity and a conductivity rating of 101% IACS. OFE stands for oxygen-free electrolytic and supersedes the term OFHC (oxygen-free high conductivity).  C10100 is the only grade of copper that comes with a written certification of purity.

VTX-Ag Cable Geometry
Shunyata’s VTX-Ag cables are uniquely constructed with both an inner, center conductor made of pure silver and an outer concentric ring conductor made of pure copper. It’s made using the finest fluorocarbon insulation to minimize dielectric absorption and re-radiation which translates to an improvement in resolution and clarity. VTX-Ag delivers the speed and clarity of silver and the midrange warmth and three dimensional power in the lower octaves of copper without imparting any of the negatives associated with either metal. – The best qualities of silver and copper combined.

Fluorocarbon Dielectrics
These ultra-high quality insulators are usually only found in wire used in the aerospace industry, satellites and the most expensive audiophile cabling. Fluorocarbon has special electrical characteristics; very low dielectric absorption, high dielectric strength and exceptional heat resistance.  When used in audio and power cables these dielectric materials reduce the perception of dynamic compression and improve low-level resolution and overall clarity.

OMEGA Terminations 
Omega demands the ultimate in connector quality to realize its performance. The Omega speaker terminal’s base metal is made from the purest OFE copper. Available with either forged Bananas or Spades these incredibly high quality connectors are available in Platinum Plated (Our preference!) or Gold Plated. These terminals deliver a crystalline sonic clarity, propulsive bass extension and a rarely achieved naturally rich tone.

Möbius Cable Suspension System
The Möbius Cable Suspension System is an integral part to the performance of the Omega speaker cables. It provides the most advanced cable isolation and support solution on the market. The Möbius features five polymer bands that sandwich the cable on all sides. These energy-absorbing bands have the unique ability to dissipate vibrational energy that travels along the surface of the cable and through the floor. The Möbius renders a significant reduction in perceived noise and time smear, yielding improved focus, clarity, depth, and spatial information. Eight Möbius wheels are included with each Omega speaker cable pair. One additional Möbius is included for each additional half meter of additional length.

Kinetic Phase Inversion Process (KPIP) v2
Shunyata Research’s proprietary Kinetic Phase Inversion Process includes four days of continuous KPIP v2™ processing which refines conductor metals at a molecular level. This dramatically reduces burn-in time and significantly improves sonic performance, delivering a relaxed and life-like presentation. When compared to the original KPIP process, KPIP v2™ represents a dramatic performance upgrade on par with a component-level upgrade.

Cable Type: ΞTRON®
Conductors: VTX-Ag
Aggregate Wire Gauge: 4 AWG
Dielectric: Fluorocarbon
Connectors: OFE Copper with Carbon fiber Accents (Unplated Copper, Gold or Platinum)
Möbius Suspension: Set of 8 included for each cable pair
TAP Modules: 4 per cable
HARP Technology: Quad-HARP
KPIPv2 Processing: 8-days
Safety Assurance:
     Continuity and polarity tests – by two technicians
     HiPOT tests insulation breakdown @ 1,200 VAC