G-Links (Set of 4)

G-Links are optional Stainless Steel spikes designed to turn your M3X2 into an amp stand. Suitable for all HRS platforms, but solely to be used with their G7 Bi-Directional Noise Reduction Feet, G-Links act as the ideal interface between the platform and any floor material.  

G-Links are intended for use where you do not already have an HRS frame system. G-Links ensure excellent coupling of the G7 equipped HRS Isolation Base to a carpeted surface or an uneven floor.  If G-Links are used on a hard surface (e.g. Wood, Stone, Bamboo etc), then Floor Protectors are recommended to preserve the surface.

Image above shows the intended use case, a set of four underneath HRS G7 feet. (Platform and G7 feet not included, Floor Protectors optional).

NOTE: HRS does not recommend the use of G-Links under any of their other footers (i.e. SF2, SF3 or LF feet).

Start with the G7 foot of the Isolation Base completely threaded into the base plinth. Place one G-Link under each of the G7 Footers on the Isolation Base. Check to make sure each G-Link is centered under each G7 footer. Once all G-Link footers are in place, check to see if all four corners of the base are stable by pressing down at each corner separately. If the base rocks at all, you should adjust one G7 foot out slightly until the base is completely stable. Do not use the G7 footers to level the Isolation Base, they are not designed to be a global leveling system. Best performance will be achieved when three of the G7 feet are completely bottomed to the base plinth and when necessary the remaining footer is adjusted out to stabilize the structure.

Dimensions: Each G-Link is 1.73" tall with a diameter of 3.47"
Weight Handling is not specified, but because of the Stainless Steel construction is probably near unlimited
A set of four G-Links weighs around 7 Lbs